How to clean the roller of the wood planer?

Wood planers are a common and indispensable tool for carpenters. It supports the surface of the wood panel to become flatter and smoother.

In the market, Planers are available in many shapes and sizes, but they all have similar components and parts that you need to adjust and clean regularly. Regular cleaning is extremely necessary. Because it keeps your planer in the best state and maintains high productivity when operating.

In today’s article, we will show about how to clean and maintain the feed rollers on your best wood planer and step by step guide following the process. Let’s start.

Types of planers

There are two main types of wood planers: thickness planers and surface planers

The best thickness planer is the best wood planer for the mone used to thicken the wood to keep the surface of the wood flat and smooth. And it gives you more control, so you can create a very suitable board thickness, ensuring that the wood is not a cone shape.

Surface planer is the best wood planer for beginners. It is the ideal tool for planing surfaces on wooden boards. Surface planers have a small advantage in that you can create a flat surface in one run. However, if you do not measure accurately the depth you need to remove from the wood, you may end up with an unusable board.

No matter what planer you have, what functions it has. The feed rollers in either of these planers should be properly cleaned to ensure proper running

Parts of a Planer

A planer is made up of three parts: a pair of feed rollers that draw across the board you are cutting; a cutting head containing a cutting knife; and a table that can be adjusted based on the cutting head so you can control the resulting thickness of the board you are cutting

Each planer has different methods for fixing tables and feed rollers and cutting heads, but they all work in similar ways.

How to clean the roller

For your planer device to work properly, the table needs to be parallel to the length of the cutter head and the rollers must hold firmly and securely to the table with the knives placed the same height. Therefore, you need your planer rollers to be clean for best performance

The feed rollers are usually made from serrated metal or rubber. Most rollers on the planer have springs and need to be regularly cleaned and adjusted to ensure that the pressure is adequate when working on a wooden surface.

Step 1: Start by unplugging the planer and removing any debris and rust from its table. Lift the assembly head or lower the table so that all areas can be cleaned.

Step 2: Clean. If you have serrated metal rollers, clean them with wire brush and solvent. If you have rubber rollers, clean them with a rag soaked in appropriate detergent.

Note: Gently wipe your rollers so you don’t damage them.

Step 3: Once you’ve cleaned all the areas, turn on your planer to spin for a minute, then turn it off and unplug it again. Repeat the above process for a second cleaning

What to do if the planer roller does not feed

Your planer roller stops feeding even though you have cleaned your feed roller. You may need to perform a few additional steps. If your planer does not feed:

  • Use a bright light to check your rollers after each use to make sure they’re clean.
  • Sharpen and reverse or replace the cut knife.
  • Make sure your feed rollers do not have any deep grooves.

If you find that the feed is still having problems, check the area where the roller is located. Occasionally, sawdust, dust, and wood chips can enter this area and cause problems. Moreover, If too much sawdust and wood chips accumulate around the feed rollers, you may observe that your end product is not perfect.

In conclusion

Proper cleaning of your feed rollers will ensure that you can use your device efficiently and safely for a long time. Like any piece of woodworking machinery, cleaning and storing your planer is an important part of maintaining its working state.

By following the steps presented above, you can ensure that you are keeping your device in the best state while creating a great product. Lastly, thank you for taking the time to read through this article.

Leave a Comment:

All fields with “*” are required

Leave a Comment:

All fields with “*” are required